Halloween Wood Pallet Fence

Last year, I begged Mr. Woodsy to make a spooky fence for our front yard. After quite a bit of convincing and brainstorming together he decided he would tackle this project for me us. We decided to use pallets to give a rustic feel and to keep the cost of materials down. Essentially this project was free for us other than all the time spent creating the fences.

Supplies:

• Wood Pallets
• Crow Bar
• Hammer
• Safety Protection
• Square (Ruler)
• Chop Saw
• Nail Gun

After a little bit of “dumpster diving” we gathered enough wood pallets to make a fence for the front of our home. Mr. Woodsy broke apart 10 pallets trying to keep the wood in as best of shape as possible. This part took the longest.

After a few long hours… the wood was off the pallets and sorted into piles. The long pieces were used as the fence backing. The shorter pieces were used as the crooked fence pieces.

We decided we wanted the edges of the fence to have points. Mr. Woodsy put the square (ruler) on the wood and marked one side of the wood pallet with the 45 degree angle.

He repeated this technique on the other side to create a perfect point.

As you see from the picture above this created an “x” on the end of the individual piece of pallet wood.

And then it was my turn to help… I knew this project was taking longer than expected. Mr. Woodsy cut a few as a template for me to use as I traced the points.  I put my gloves on and got to work marking each and every piece of wood.

Mr. Woodsy cut all the pieces of wood at a 45 degree angle, then flipped the saw and cut the other 45 degree angle; creating a point.

He used a 1″ X  4″ x 6′  for the fence panels, making sure to measure and create an equal distance from the top board to the bottom board. Then space out the pallets on top to create you spooky fence look.

Using a nail gun, at every connection, put a couple of nails to insure stability in your fence.

On the ends of every other fence section Mr. Woodsy had a vertical panel over hang the horizontal boards, so it will receive the next panel and look like one smooth continuous fence.

I had asked Mr. Woodsy to keep all the fence spikes short enough to keep in the attict. He insisted we have some tall and some short. Once he made his first fence I asked him to do a “attic check” to make sure we would be able to store these away for years to come. Sure enough (I was right) these fences were not going to be able to fit in the attic. Even after knowing this he insisted we would have them long this year and then when it was time to store them in the attic he would cut the tall ones to size. Needless to say we have the best neighbor ever and she stored them for us in her garage!

This is what the backs of the fence looks like. Mr. Woodsy numbered each piece so that you can put them together like a puzzle.

Mr. Woodsy laid the 4 fence panels out on the side walk in preparation for being installed.

He drilled the fence panel to a wood stake he created as additional reinforcement for the panel.

Installing the other side of the fence.

This is what the fence looks like completely assembled. Mr. Woodsy kept it to one panel going up our driveway.

This was the end of our property line. I wanted the fence to go all the way up the side, but I knew that wasn’t going to happen.

Decorate your wood pallet fence with tons of moss. We got ours for free just by walking into the woods near our home.

On Halloween night… this is what our fence looked like in all its glory!

Share and Enjoy